About the role#
Castings move during heat treat, and your job is to get them back in spec. You will design the straightening process, connect it to machining results, and tighten it until parts come out right the first time. You will work alongside engineers and operators on the floor to own a real project, rather than shadowing. At the end of the summer, you will present your findings and recommendations to leadership.
What you'll need#
- Pursuing a degree in mechanical or industrial engineering.
- Experience reading dimensional scans or inspection reports.
- Working knowledge of GD&T.
- Ability to investigate root causes and pay close attention to measurements and tolerances.
- Bonus qualifications include SolidWorks or fixture design experience, hydraulics coursework, or shop-floor experience.
What you'll do#
- Design and implement hydraulic straightening for heat-treated castings.
- Read dimensional scans and CMM data to determine where and how much parts move.
- Tie machining results back to straightening fixtures to identify causes of out-of-spec parts.
- Improve fixtures, setups, and methods to reduce rework.
- Make the straightening process safer and less dependent on operator feel.
- Report scrap dollars saved, time saved in heat treat and straightening, and safety improvements.
Location & details#
- Location: Manitowoc, Wisconsin.
- Term: Summer 2027.
- Status: Paid, full-time, on-site.


